Creates a surface or solid by driving a curve in a straight line perpendicular to the construction plane.
Note: Unlike Lofts
and Sweeps
, the initial orientation of the profile curve or surface is maintained through the extrusion.
Steps:
-
Select
a curve.
-
Pick
a distance.
Options
Direction
BothSides
Cap
DeleteInput
|
History enabled…
|
Extrude > Extrude Straight
Surface > Extrude Curve > Straight Related topics… |
Extrudes a curve along a path curve.
Note: Unlike Lofts
and Sweeps
, the initial orientation of the profile curve or surface is maintained through the extrusion.
Steps:
-
Select
a curve.
-
Select the path curve.
Options
Cap
DeleteInput
Extrude a curve the distance specified by picking two points along a curve.
Note: The extruded surface starts from the beginning of the curve, not the first picked point. Picking the points only establishes the extrusion distance.
Steps:
-
Select
the path curve.
-
Pick
a start along the path curve.
-
Pick an end along the path curve.
|
History enabled…
|
Extrude > Extrude Along Curve
Surface > Extrude Curve > Along Curve Related topics… |
Creates a surface or solid by extruding a curve to a tapered polysurface.
Note: Unlike Lofts
and Sweeps
, the initial orientation of the profile curve or surface is maintained through the extrusion.
Steps:
-
Select
a curve.
-
Pick
a distance.
Options
Direction
DraftAngle
Cap
Corners
DeleteInput
FlipAngle
|
History enabled…
|
Extrude > Extrude Tapered
Surface > Extrude Curve > Tapered Related topics… |
Creates a surface or solid by driving a curve to a pointed surface.
Note: Unlike Lofts
and Sweeps
, the initial orientation of the profile curve or surface is maintained through the extrusion.
Steps:
-
Select
a curve
-
Pick
the point to extrude to.
Options
Cap
DeleteInput
|
History enabled…
|
Extrude > Extrude to Point
Surface > Extrude Curve >To Point Related topics… |
Creates a surface by extruding a curve on a surface, normal to the surface.
Steps:
-
Select
a curve on the surface.
-
Select the surface.
-
Pick
a location on the curve for a height.
-
Pick a location to set another height, or press Enter
if the surface should be uniform in height.
Extrude > Extrude curve normal to surface
Surface > Extrude Curve > Normal to Surface Related topics… |
Creates a surface by offsetting a curve and creating a ruled surface in the area between the two curves.
Steps:
-
Select
a curve.
-
Drag the cursor to one side of the curve and pick.
Options
Distance
Corner
ThroughPoint
Tolerance
BothSides
Extrude > Ribbon
Surface > Extrude Curve > Ribbon Related topics… |
Offsets a curve, extrudes and caps the result to create a solid.
Steps:
-
Select
a curve.
-
Note: The Slab command uses the construction plane in the view where you pick the offset as the ground plane. The Slab command offsets the curve to create a base for the slab and then extrudes the base to make a solid with mitered corners.
-
Pick
a distance.
-
Pick the height.
Options
Distance
ThroughPoint
Extrude Solid > Slab from polyline
Solid > Slab Related topics… |